Sony PDW-HR1 Operation Manual page 143

Item number Item name
013 SYSTEM FREQUENCY
SELECT MENU
016 ALARM DISPLAY
017 SUB STATUS DISPLAY SELECT Determine the kind of sub status information to be output from the
024 MENU CHARACTER TYPE
027
SD CHARACTER
028
HD CHARACTER
Settings
Specify whether to enable switching the system frequencies (59.94i, 59.94P,
29.97P, 50i, 50P, 25P, 23.98P).
off: Do not enable switching the system frequencies.
on: Enable switching the system frequencies.
For details about switching the system frequencies, see page 51.
Note
Settings for both basic and extended menu items are saved separately for
different system frequencies.
• 1080 59.94i/29.97P
• 1080 50i/25P
• 1080 23.98P
• 720 59.94P
• 720 50P
Therefore, when you switch system frequencies, all menu items are reset to
the current settings for the new mode. (They are different from the setting for
the previous mode.)
Select whether to display alarm messages.
off: Do not display alarm messages. (However, certain important alarms are
displayed.)
limit (on (limited)): Display only a minimum number of alarm messages.
on: Display all alarm messages.
For details about alarm message display conditions, see "Alarms"
(page 177).
COMPOSITE OUT connector, the SDSDI OUTPUT connector, or the
HDSDI OUTPUT 2 (SUPER) connector.
off: Do not output sub status information.
rmain (disc remain): Available disc space (unit: minute)
clip (clip no): Order of playback of the selected clip/total number of clips
pbr (playback remain): The remaining playback time of the selected clip
from the current playback position (hours:minutes:seconds:frames).
Note
When menu item 005 is set to "off", sub status information is not displayed
when this item is set to anything other than "off".
Determine the type of characters in menu text output from the COMPOSITE
OUT connector, the SDSDI OUTPUT connector, or the HDSDI OUTPUT 2
(SUPER) connector for superimposed display on the monitor.
white: White letters on a black background.
black: Black letters on a white background.
W/out: White letters with black outline.
B/out: Black letters with white outline.
Set this item by selecting the required type while viewing the monitor.
Specifies whether to superimpose text information on the video signals
a)
output from the COMPOSITE OUT and SDSDI OUTPUT connectors.
off: Do not superimpose.
all: Superimpose on the output of both the COMPOSITE OUT and SDSDI
OUTPUT connectors.
comp (composite): Superimpose on the output of the COMPOSITE OUT
connector.
sdi: Superimpose on the output of the SDSDI OUTPUT connector.
a) Specify whether to superimpose text information on the video signal output
from the HDSDI OUTPUT 2 (SUPER) connector.
off: Do not superimpose.
sdi2 (hd-sdi2): Superimpose.
143
Setup Menu