Delete Button; Editing Operation Section; Preview Button; Edit Button - Sony PDW-HR1 Operation Manual

d ALL/CH-1 and CH-2 to CH-4 adjustment knobs
These knobs adjust the audio levels of channels 1 to 4 (CH-
1 to CH-4). The knobs in the upper row adjust recording
levels, and the knobs in the lower row adjust playback
levels. These settings are enabled when the corresponding
VARIABLE/PRESET switch is set to VARIABLE.
You can use the function menu to adjust channels 5 to 8.
For details, see page 59.
Setup menu item 131 AUDIO VOLUME allows you to
enable simultaneous adjustment of all eight channels with
the ALL/CH-1 knob. The ALL indicator lights when
simultaneous adjustment is enabled.

5 Editing operation section

1 EDIT button

2 RECALL button

3 DELETE button

4 GOTO button
8 UNDO button
7 AUTO EDIT button

6 PREVIEW button

a EDIT button
Switches to the edit list editing screen (see page 109).
Note
The scene selection function is disabled in the edit list
editing screens.
b RECALL button
When pressed together with the IN button or the OUT
button after deleting the In or Out point of a clip or sub
clip, recalls the In or Out point.
When pressed in the EDIT LIST screen, switches to the
Clip List (Trim) screen, so that you can trim the positions
of In and Out points (see page 118).
5 – and + TRIM buttons
q; ENTRY button
9 IN and OUT buttons
c DELETE button
Deletes an In or Out point in a clip or sub clip. Delete the
point (if it exists) by holding down the IN or OUT button
and pressing this button.
d GOTO button
Jumps to an In or Out point in a clip or sub clip. Jump to
the point (if it exists) by holding down the IN or OUT
button and pressing this button.
e – and + TRIM buttons
Trim an In or Out point in a clip or sub clip. Trim the point
(if it exists) by holding down the IN or OUT button and
pressing the [–] or [+] button. The In or Out point moves
one frame forward or back.
When an edit list editing screen is displayed, the + TRIM
and – TRIM buttons enlarge or reduce the time scale of the
timeline. When a sub clip is selected in an edit list editing
screen, these buttons function as trim buttons for audio
split editing (see page 121) if you press them while
holding down the GOTO button.
Note
Audio split editing function is enabled when the PDBZ-
UPG03 Software Upgrade Key or PDBK-MK1 option
board is installed.
f PREVIEW button
Flashes when preview is possible.
The editing screen switches to full-screen mode and one of
the following sections are played back, depending on the
screen that was displayed when you pressed the button.
RECORDER mode screen: The editing section,
including preroll and postroll sections.
PLAYER mode screen: The editing section only.
Note
When PLAYER SEL in the Edit Menu is set to "external"
and EDIT MODE is set to "insert", the postroll section is
not played, even if you press the button in RECORDER
mode.
g AUTO EDIT button
Flashes when auto editing is possible.
Updates an edit list by adding material in the specified
editing mode at the location specified by an edit point.
When two edit points or less have been set, the editing
screen changes into full-screen playback of a section until
the edit section is confirmed, including the preroll and
postroll sections.
Note
The preroll and postroll sections are not played when
PLAYER SEL in the Edit Menu is set to "external".
27
Control Panel