Uploading Clips - Sony PDW-HR1 Operation Manual

To enable the UPnP function
The UPnP (universal plug and play) function allows
devices to be easily connected to networks. The following
XDCAM devices support UPnP.
• PDW-F1600
• PDW-HD1500
• PDW-HR1
• PDW-F800
• PDW-700
To enable the UPnP function on this unit, set maintenance
menu item M59: UPnP to ENABLE, and then power the
unit off and on again.
For the settings on other XDCAM devices, refer to the
operation manuals supplied with the devices.

Uploading clips

To upload entire clips
Proceed as follows to upload selected clips or all clips and
clip lists on the disc.
See page 78 for more information about GUI screen
operations.
1
In the clip thumbnail screen, select the clip to upload
(multiple selections possible).
To upload all clips and clip lists on the disc, start from
step 2.
2
Display the Thumbnail Menu.
3
Select Upload Clips via Direct FTP, and then press the
PUSH SET knob.
The Select Transfer Type screen of the Upload Clips
via Direct FTP command appears.
4
Select the type of clip transfer.
Selected Clips: Clips selected in step 1.
All Clips & ClipList: All clips and clip lists on the
1)
disc.
1) Immediately after execution of a clip filtering operation, this item
changes to "All Filtered Clips" (all clips selected by the filtering
operation).
To transfer while preserving the UMID of the
transfer source clips
Check the "UMID Unchanged" option.
Note
If the remote host is a computer, clips are transferred
with the UMID unchanged regardless of this setting.
To reconnect to a remote host
The Reconnect button is enabled if the most recent
operation successfully established a connection to a
remote host.
You can select "Reconnect" and press the PUSH SET
knob to reconnect to that host. The host is selected
automatically and the screen changes directly to the
Connecting Status screen (see step 9 in the procedure).
Note
The Reconnect button is not enabled if the most recent
operation failed to connect to a remote host.
5
Select ,, and then press the PUSH SET knob.
The Select Remote Host screen appears.
6
Select the remote host (the target device to which you
want to transfer the clips).
You can register up to four remote hosts.
Remote Host 1 to 3: Register these in the settings
screen.
Remote Host 4(UPnP): A remote host that supports
UPnP (universal plug and play) is detected and
registered automatically (see "To enable the
UPnP function" (page 103)).
To check remote hosts discovered by the UPnP
function
Select "Hosts Discovered via UPnP", and then press
the PUSH SET knob. (If the UPnP function of this unit
is disabled, a confirmation screen appears prompting
you to enable it. Select "OK" and then press the PUSH
Transferring clips (Direct FTP function)
103