Figure 4-6. Securing The Adapter Module To The Front Panel - Nortel 114200-E Installation And Operating

3.
4.
1
2
Figure 4-6.
5.
6.
7.
Note: See your module-specific Supplement for information about the LEDs
on the newly installed module. The new module's LEDs will not indicate data
transfer until you have configured and enabled software services.
114200-E Rev 00
Push the adapter module in until its connector pins align with the base
module connector socket in the ARN chassis.
Using a Phillips screwdriver, insert and tighten the screw
ISDN
DSU/CSU
Securing the Adapter Module to the Front Panel
Remove the antistatic wrist strap.
Connect the appropriate WAN cabling to the new interface.
For cabling information, see the module-specific Supplement and the Nortel
Networks Cable Guide.
Turn power on, and check the diagnostic LEDs on the front panel of the
base module.
See ""Ensuring a Successful Installation" on page 3-9.
If the module fails its diagnostic test, the Fail LED remains on and the module
LED flashes rapidly.
Installing a WAN Adapter Module
ARN0033A
(Figure 4-6).
4-7