Table of Contents
Advertisement
To use the directed netboot feature:
1.
2.
3.
114200-E Rev 00
At the command line prompt, enter the
by your network administrator and press the Return key.
The following is a sample command:
ifconfig com1 9.0.0.2 255.0.0.0 9.0.0.3
For more information about the
Command" on page A-2.
Enter the
commands provided by your network administrator
bconfig
and press the Return key.
You must enter one
bconfig
image, and another to specify the location of the configuration file.
The following are sample commands:
bconfig image network 192.32.5.8 /usr/arnstartup/arn.exe
bconfig config network 192.32.5.8 /usr/arnstartup/config
For more information about the
Command" on page A-7.
Type the following command and press the Return key to verify the
configuration you specified in Step 3:
getcfg
The get configuration data command
image file and network configuration file, the interface configuration settings
that you specified using the
information and file paths that you specified using the
Verify the interface configuration, as shown in
ifconfig
command, see "Using the ifconfig
ifconfig
command to specify the location of the software
command, see "Using the bconfig
bconfig
shows the location of the boot
getcfg
command, as well as the TFTP server
ifconfig
Figure
Starting the ARN
command provided to you
commands.
bconfig
2-1.
2-11
Advertisement
Table of Contents
