Leds; Front Panel Leds - Nortel VPN Router 1750 Installation Manual

Hide thumbs Also See for VPN Router 1750:
Table of Contents

Advertisement

26 Chapter 1 Cables and power

LEDs

This section describes the LEDs on the front panel of the VPN Router 1750 and
on the interface cards that use LEDs. You can confirm that you properly connect
the LAN and WAN interface cables by examining the LEDs.

Front panel LEDs

The front panel of the VPN Router 1750 has a lighted Nortel logo and two LEDs
as shown in the following figure. These LEDs indicate the status of the VPN
Router 1750.
Figure 2 Front panel LEDs
The following table describes the LEDs on the VPN Router 1750 front panel.
Table 3 Front panel LED indicators
LED
Power (Nortel
logo)
Alert
Boot/Ready
For more information about the health check, event log, and system log, see
Nortel VPN Router Troubleshooting — Server (NN46110-602).
NN46110-316 03.01
Alert
Boot/Ready
Indicator
Description
On
The gateway receives AC power.
Off
The gateway does not receive AC power.
Yellow
A nonfatal alarm condition exists. The health check
display describes the yellow alert condition.
Red
A serious alarm condition exists that requires attention.
A red alert usually indicates a hardware error. The health
check display describes the red alert condition.
Yellow
The gateway is starting and is in a nonready state.
Green
The boot process is complete, and the gateway is in a
state of readiness.
Get other manuals https://www.bkmanuals.com
Power
Alert
Boot/Ready
CS160013A

Advertisement

Table of Contents
loading

Table of Contents