4.
1
2
Figure 4-1.
5.
Removing the Filler Panel
To remove the filler panel from an empty adapter module slot:
1.
114200-E Rev 00
Determine which of the two front-panel adapter module slots to use
(Figure
4-1).
Tx
Telco
DSU/CSU
Rx
Location of Adapter Module Slots 1 and 2
Remove the installed adapter module or the slot filler panel.
•
To install the adapter module in an empty slot, go to
"Removing the Filler
•
To replace an installed adapter module, go to
"Removing an Adapter
Using a Phillips screwdriver, remove the screw that secures the filler
panel in either slot 1 or slot 2
ARN front panel
RLSD
DTR
ARN0076A
Panel" on
page
4-3.
Module" on
page
(Figure
4-2).
Installing a WAN Adapter Module
4-5.
4-3