Table of Contents
Advertisement
Table B-1
Quick-Start procedure.
Table B-1.
Interface*
Ethernet
Token Ring
Serial
56/64K, FT1/T1, or
FE1/E1 DSU/CSU
* The Quick-Start script does not support initial ISDN, X.25 PAD, or V.34 interface
configuration.
Filling Out the Worksheets
The inst_arn.bat script provides many options for configuring the ARN on a
network. Since typical remote access uses a serial interface over a wide area
connection, this sample describes only the options involved with a serial
configuration.
Note: This section provides worksheets only for a serial interface
configuration over a wide area connection. It does not contain worksheets for
LAN configuration options. If configuring a LAN interface, read the
Quick-Start text and prompts carefully before responding, as they will differ
from the serial sample.
We suggest the following procedure when you fill out worksheets:
1.
2.
114200-E Rev 00
provides the connector names and numbers you should use during the
Quick-Start Connector Names and Numbers
Module
Base
XCVR1
MAU1
N/A
N/A
Fill out the Global Information Worksheet completely.
The sample worksheet lists options common to all serial interface
configurations.
After you record your protocol selections on the Global Information
Worksheet, fill out one Router Protocol worksheet.
Using Local Boot (the Quick-Start Procedure)
Expansion
Adapter 1
XCVR2
N/A
MAU2
N/A
COM3, COM4,
COM1
or COM5
N/A
COM1
Adapter 2
N/A
N/A
COM2
COM2
B-3
Advertisement
Table of Contents
