Table of Contents
Advertisement
Installing and Operating Passport ARN Routers
OSPF Worksheet
Requested Information
Enter OSPF MTU size selection [1]:
Enter OSPF interface type selection
[1]:
Enter decimal value in seconds for
Hello Interval [10]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
Enter decimal value in seconds for
Router Dead Interval [40]:
Note: This value must match all other
interfaces in the OSPF area for
connection to take place.
Enter decimal value for Router Priority
[1]:
(For Broadcast, NBMA, or
Point-to-MultiPoint)
B-10
(continued)
Options
1. Default
2. Ethernet size (Nortel Networks
3. User Defined MTU
1. Broadcast
2. NBMA
3. Point-to-Point
4. Point-to-Multipoint (Proprietary)
5. Point-to-Multipoint (Per OSPF
Note: When using a wide area
protocol other than Nortel
Networks Proprietary PPP , you
should select NBMA.
The script suggests the following
intervals:
Broadcast -- 10 seconds
Point-to-Point -- 15 seconds
NBMA -- 20 seconds
Point-to-MultiPoint --10 seconds
The script suggests the following
intervals:
Broadcast -- 40 seconds
Point-to-Point -- 60 seconds
NBMA -- 80 seconds
Point-to-MultiPoint (STD) -- 40
seconds
Enter a router priority value. The
lower the value (above zero), the
higher the priority.
Note: If you set the router priority
to zero (0), the router is not eligible
to become the designated router
on this network.
Series 5 compatible)
Standard)
Your Response
(continued)
114200-E Rev 00
Advertisement
Table of Contents
