Installing and Operating Passport ARN Routers
Resetting the ARN
The Reset button is set inside the ARN back panel and resides next to the flash
card slot, as shown in
100-240~
1.2A
50-60Hz
Figure 3-3.
ARN Reset Button
To press the Reset button, insert a small pointed object (for example, a paper clip)
into the Reset button hole.
u can use the Reset button to reboot the ARN hardware without cycling power,
Yo
as follows:
•
To warm-boot the ARN (no diagnostic tests run), press the Reset button for
less than 5 seconds.
•
To cold-boot the ARN (diagnostic tests run), press the Reset button for more
than 5 seconds.
Note: If you reset the ARN while it is running its diagnostic tests, the LEDs
remain in the state they were in when you pressed the Reset button. You must
cycle power on the ARN to reset the LEDs.
3-12
Figure
U L
Redundant Power
U L
3-3.
Reset button
Console
Modem
ARN0052A
114200-E Rev 00