Table of Contents
Advertisement
Installing and Operating Passport ARN Routers
Rack-Mounting the ARN
For this procedure, you need:
•
Two flange brackets and eight #6 Phillips screws (shipped with the ARN)
•
A Phillips screwdriver
•
An electronic enclosure rack. If the rack does not have threaded rail holes, you
must attach the four cage nuts shipped with the ARN.
•
Four #10 cagenut screws and washers (shipped with the ARN)
To rack-mount the ARN:
Determine how you want the ARN to fit in the equipment rack.
1.
Multiple holes in the flange brackets provide several options for
rack-mounting the ARN. How you attach the flange brackets determines how
far the router extends outside or remains inside the rack.
three of the most common locations for the brackets.
Attach a flange bracket to each side of the ARN.
2.
a.
b.
c.
1-6
Align four bracket holes with four holes in the ARN enclosure
(Figure
1-2).
Insert a #6 Phillips screw through each hole and into the ARN.
Tighten the four screws with a Phillips screwdriver.
Figure 1-2
shows
114200-E Rev 00
Advertisement
Table of Contents
