Connecting To The Fiber Interface; Connecting To A Token Ring Interface - Nortel 114200-E Installation And Operating

Connecting to the Fiber Interface

To connect a fiber cable to the base module or expansion module Ethernet
interface, insert the fiber cable jack into the interface as shown in
U
D B1
1
ISDN BRI
DD B2
withNT1
COM
2
RLSD
Serial
Figure 1-8. Connecting an Ethernet 100BASE-Fx Cable

Connecting to a Token Ring Interface

You can connect a token ring cable to any ARN base module or expansion module
that contains a token ring interface option. Each of these interface options offers
two token ring interface types: an STP interface or a UTP interface.
Note: You can use only one token ring interface on an ARN base or expansion
module at any time. For example, you can connect to either the STP interface
or the UTP interface on a base module, but you cannot use both interfaces at
the same time.
114200-E Rev 00
Expansion module 10BASE-T interface
10BaseT
Tx
AUI
Rx
Cl
Ethernet 2
Tx
100 BaseFX
Rx
Link
100
Ethernet 1
To
Ethernet
network
Base module 100BASE-FX interface
RLSD3 COM3
RLSD4
RLSD5
Run Pwr Base Expansion
Boot RPS Adapter1 DCM
Diag Fan Adapter2 PCMCIA
Ethernet 100BASE-FX cables
Installing the ARN
Figure 1-8.
COM4 COM5
Serial
Advanced Remote Node
ARN0062C
1-13