Nortel 114200-E Installation And Operating page 68

Installing and Operating Passport ARN Routers
Figure 2-1.
If
correct and reenter the
assistance, contact your network administrator.
Type the following command and press the Return key to boot the ARN:
4.
Note: If the ARN cannot find a software image file or a configuration file
using the directed netboot procedure, it attempts to netboot once. If the netboot
procedure fails, the ARN tries to local boot once. If all three boot attempts fail,
the ARN continues to try directed netboot, netboot, and local boot until it
boots successfully. If the ARN remains in this loop, follow the steps in
"Interrupting the Boot Process" on
Ensure that the ARN boots correctly.
5.
When the ARN boots, its LEDs flash in a particular order. To ensure that the
installation was successful, see "Ensuring a Successful Installation" on
"Ensuring a Successful Installation" on page 3-9.
2-12
$ getcfg
Boot Options
boot image = network
boot config = network
host IP address = 192.32.5.8
image pathname =
"/usr/arnstartup/krnl_arn.exe"
config pathname =
"/usr/arnstartup/config"
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...IP=9.0.0.2, Mask=255.0.0.0, Next Hop=9.0.0.3
COM2...EZ-Install (disabled)
COM3...EZ-Install (disabled)
COM4...EZ-Install (disabled)
COM5...EZ-Install (disabled)
Verifying Directed Netboot Configuration
displays the correct information, continue to Step 4. Otherwise,
getcfg
boot
and
ifconfig bconfig
page 2-6.
ARN0080A
commands. If you need
114200-E Rev 00