Using Netboot, Directed Netboot, Or Local Boot; Interrupting The Boot Process - Nortel 114200-E Installation And Operating

Installing and Operating Passport ARN Routers

Using Netboot, Directed Netboot, or Local Boot

When you netboot or local boot the ARN, you must use a command line interface
that accesses the router software. To use a command line interface, you can:
• Wait for the ARN to local boot (that is, wait for the router to fail EZ-Install
and then attempt to boot using its local configuration file). After the ARN
boots locally, you can log in to the Technician Interface and redefine the boot
process.
• Interrupt the boot process using a break sequence and log in to the ARN
monitor to redefine the boot process.
Using the netboot, directed netboot, or local boot options requires that you:
• Connect any necessary communications cables to access the network.
• Connect a management console.
• Connect the ARN power cable.
• Install a flash memory card.
See Chapter 1, "Installing the ARN" for instructions on how to complete these
tasks.

Interrupting the Boot Process

Interrupting the boot process automatically starts the ARN monitor. Using the
ARN monitor allows you to bypass the EZ-Install procedure.
Note: Before you power on the ARN, make sure that you have installed the
router and connected the management console equipment you need (see
"Connecting a Management Console" on page 1-23).
To interrupt the boot process:
Press the power switch on the ARN back panel to the On position.
1.
As the router powers on, your console displays the ARN diagnostic tests.
After successfully completing these tests, the router begins the EZ-Install
procedure and attempts to boot over the network.
2-6
114200-E Rev 00