Table of Contents
Advertisement
Settings Page: Network Setup Settings (Cont.)
TABLE 4
Option
Netmask
Gateway address
Trial Save
Status Section
The Status section of the Settings page is shown in
Status Section
FIG. 7
Settings Page: Status Section
TABLE 5
Option
HDMI Status
Input Resolution
HDMI Status Pass Thru
Current Bandwidth
Port 50001 Source IP
Port 50002 Source IP
Serial Source IP
Flush buttons
KVM IP
N2000 Series User Manual
Description
View the current Netmask of the N2000 Encoder. When
in STATIC mode, enter a new Netmask into this field.
View the current Gateway address of the N2000
Encoder. When in STATIC mode, enter a new Gateway
address into this field.
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
Figure
Description
Indicates if a video source is connected to the Encoder.
Indicates the video resolution of the currently
connected source.
Indicates if a display device is connected to the
Encoder.
This is a snapshot of the unit as properties were loaded
to the browser, not a live counter. Refresh the page to
get an updated bandwidth.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
These buttons reset the port.
Shows the IP address of the KVM Decoder currently
connected to this Encoder.
Notes
7. Options are described in
Table
Notes
Port 50001 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Port 50002 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
This setting only applies to the N2135.
Encoder Configuration Options
5.
35
Advertisement
Table of Contents
