Titan TTB674TAS Instruction Manual page 51

TTB674TAS by TITAN
Lubrication
> All motor bearings are permanently lubricated at the factory, and do not require
any additional lubrication.
> Use graphite or silicone to lubricate all mechanical parts of the table saw where
a pivot or threaded rod is present.
> Dry lubricants do not hold sawdust like oil or grease.
To replace the saw blade
When you need replace the saw blade, please follow the procedure as belowing:
> Unplug the saw.
> Loosen the hex nut and remove the blade guard.
> Turn the bevel adjusting handwheel to set the saw blade to 90° and lock the
bevel-locking handle, then turn height adjusting handle clockwise to drop the
saw blade to lowest position.
> Loosen the eight cross-screws and remove the table insert.
> Turn height adjusting handle counterclockwise to raise blade to maximum height.
> Using one opened-ended blade wrench [23], place the flat open end on the flats
on the outer blade flange [67].
> Using the other opened-ended blade wrench [23], place the flat open end on the
flats on the arbor nut [68]. Holding both wrenches firmly, pull the opened-ended
blade wrench [23] on the arbor nut forward to the front of the machine.
WARNING! Arbor shaft has left-hand threads. Be extremely
careful when loosening arbor nut. Keep firm grasp on both
wrenches. Do not allow hands to slip and contact blade.
> Remove arbor nut [68], outer blade flange [67] and saw blade [2].
> Place one new blade [2] on arbor shaft [69]. Make sure saw blade teeth point
down at the front side of saw table. Place outer flange [67] and arbor nut [68]
on arbor shaft and verify that large, flat surface of the outer flange faces the saw
blade and the saw blade (2) is firmly seated aganist the inner flange (70). And
all the items are snug against the arbor housing.
> Use blade wrenches to tighten nut securely. Do not overtighten.
WARNING! Product damage! When installing, make sure to heed
the turning direction of the saw blade!
Care and maintenance
GB
IE
51