Titan TTB674TAS Instruction Manual page 30

TTB674TAS by TITAN
GB
IE
To mount the table saw onto the
workbench
If the stand is not used, the table saw must be properly secured to a sturdy
workbench using the four mounting holes on the saw base.
> Place the table saw over the workbench tabletop and mark four locations on top
of the workbench by setting the mounting holes at the saw base.
> Drill four mounting holes at the marked location of the workbench.
> Place the table saw on the workbench and align the mounting holes of the table
saw with the drilled holes in the workbench.
> Firmly screw the table saw to the bench surface.
Carefully check the workbench after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
To attach the dust extraction adapter
and dust extraction hose
> Attach the side A [54] dust extraction adapter [27] to the dust extraction port [55]
on the rear of the table saw as shown in the Fig. 21.
Fig. 21
30
Warning: Dust extraction must be fitted and the table saw must
regularly check for dust build up and cleaned frequently, otherwise
there is a risk of heat built up and potential fire.
Before you start
55 54 27