Table of Contents
Advertisement
TTB674TAS by TITAN
> Loosen the blade bevel locking handle [10] and tilt the bevel adjusting handwheel
[8] to 90° and turn height adjusting handle [6] to raise the blade to its highest
position. Tighten the blade bevel locking handle [10]. (Refer to the sections "bevel
locking handle", "bevel adjusting handwheel" and "height adjusting handle" on
Page 35-37).
> Loosen the tri-wing knob [48] to insert the riving knife [24] and push it down,
when you hear a "click", the pin [49] is locked into the hole on the riving knife
[24].
> Tighten the tri-wing knob [48].
> Reinstall the table insert [17].
49
Fig. 10
NOTE: The riving kinfe must be aligned with saw blade after
finished and the distance between the outside edge of the saw
blade and the riving knife must be not more than five millimetres.
If not, please contact with your dealer, because riving knife of this
table saw not need be adjusted.
24
Max. 5mm
48
Before you start
Fig. 11
GB
IE
23
Hide quick links:
Advertisement
Table of Contents
