TTB674TAS by TITAN
GB
IE
To assemble the stand
> Bolt the long & short top leg brackets [35, 36] and long & short bottom leg brackets
[37, 38] to the stand legs [39] using screws M6 x 12 [40], flat washers 6
[28], spring washers 6 [29] and hex nuts M6 [30]. Only hand-tighten the hex nuts
for the time being.
Important: There are two different sizes of parts 35, 36, 37,38 these must be
assembled opposite each other. For example part 35 must be above part 37.
> Tighten all bolted connections.
> Push the rubber foot [4] onto the stand legs [39].
40
Fig. 19
28
NOTE: The table saw can now be operated firmly mounted on a
workbench.
29
28
30
35
36
37
38
4
40
Before you start
36
39
35
38
37
28
29
30