Check Before Starting - Titan TTB674TAS Instruction Manual

TTB674TAS by TITAN
GB
IE
> To prevent sawdust buildup, for best result, attach a vacuum hose (not included)
to the side C [58 ] of the dust extraction adapter [27] (See Fig. 22). DO
NOT operate the saw with hose in place unless the vacuum is turned on.

Check before starting!

Check the safe condition of the product before plugging the power cable:
> Check whether there are any visible defects.
> Check whether all parts of the device are firmly attached.
> Check whether the safety equipment is in faultless condition.
> Check whether the saw blade can run freely.
> Check whether the adjusting screw of the tilt setting is tightened.
Connection to the electrical supply
> Before switching on, make sure that the voltage of the mains supply is the same as
indicated on the rating plate. This product is designed to operate on 230-240V~
50Hz. Connecting it to any other power source may cause damage.
32
Warning: Risk of injury!
In case of malfunctions, press the red 0-Button on the On/Off
switch [7] and pull out the mains plug.
Warning: Risk of injury!
The table saw must only be put into operation if no faults
are found. If a part is defective, it must absolutely be replaced
before the next use.
Before you start