Titan TTB674TAS Instruction Manual page 11

TTB674TAS by TITAN
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR TABLE SAW
> Wear eye protection.
> Do not use the tool in presence of flammable liquids or gases.
> NEVER use the tool with an abrasive cut-off wheel installed.
> Check the blade carefully for cracks or damage before operation. Replace
cracked or damaged blade immediately.
> Use only saw blades recommended by the manufacturer and which conform
to EN847-1, and observe that the riving knife must not be thick er than the
width of the cut by the saw blade and not thinner than the body of the blade.
> Always use accessories recommended in this manual. Use of improper
accessories such as abrasive cut-off wheels may cause an injury.
> Select the correct saw blade for the material to be cut.
> Do not use saw blades manufactured from high speed steel.
> To reduce the emitted noise, always be sure that the blade is sharp
and clean.
> Use correctly sharpened saw blades. Observe the maximum speed marked
on the saw blade.
> Clean the spindle, flanges (especially the installing surface) and hex
nut before installing the blade. Poor installation may cause vibration/wobbling
or slippage of the blade.
> Use saw-blade guard and riving knife for every operation for which it can be
used, including all through sawing operations. Always install the blade guard
following the instructions out-lined in this manual. Through sawing operations
are those in which the blade cuts completely through the work piece as
in ripping or cross cutting. NEVER use the tool with a faulty blade guard or
secure the blade guard with a rope, string, etc. Any irregular operation of the
blade guard should be corrected immediately.
> Immediately reattach the guard and riving knife after completing an operation
which requires removal of the guard.
> Do not cut metal objects such as nails and screws. Inspect for and remove
all nails, screws and other foreign material from the work piece before
operation.
> Remove wrenches, cut-off pieces, etc. from the table before the switch is
turned on.
> NEVER wear gloves during operation.
> Keep hands out of the line of the saw blade.
NEVER stand or permit anyone else to stand in line with the path of the saw
>
blade.
> Make sure the blade is not contacting the riving knife or work piece before the
switch is turned on.
Technical and legal
information
GB
IE
11