Titan TTB674TAS Instruction Manual page 26

GB TTB674TAS by TITAN
IE
> Tighten all the hex nuts M6 [30] of the rails.
> Loosen the rip fence locking handle [22], place the rip fence on the desired position
of the working table, keep the rip fence is level on the working table, then push
down the rip fence locking handle [22] in order to lock the rip fence in position.
Fig. 16
To assemble the blade gurad
> Attach the blade guard [14] over the riving knife so that the holes in the blade
guard [14] and riving knife are aligned.
> Insert the screw M6 x45 [46] and fit the flat washer 6 [47] and hex nut M6 [45].
> Tighten the hex nut M6 [45] sufficiently so that the blade guard rests on the table
top but will lift when the work piece is pushed into the table.
> Blade guard MUST be in place.
26
WARNING: Risk of injury!
The saw blade guard [14] must be in position at all times
to prevent contact with the saw blade. It should lift up and onto
the work piece when the work piece is passed through the saw.
WARNING: The blade guard should return to its rest position after
the work piece has been cut.
Before you start
22