Trouble Shooting - Titan TTB674TAS Instruction Manual

TTB674TAS by TITAN

Trouble shooting

Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section.
In most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualified specialist if you cannot solve the problem yourself!
Problem
Motor not running. 1. No mains voltage.
Blade makes poor
cuts.
Excess vibration. 1. Blade is out of balance.
bevel adjusting
handwheel is hard
to turn.
Possible cause
2. Undervoltage relay
triggered by temporary
loss of power.
3. Motor overheated.
1. Blade is dull or dirty.
2. Blade is the wrong type
for cut being made.
3. Blade is mounted
backwards.
2. Blade is damaged.
3. Saw is not mounted
securely.
4. Work surface is uneven.
5. Blade is warped.
1. Gear and screw post
inside the cabinet are
clogged with sawdust.
Trouble shooting
Solution
1. Check cable, plug,
socket and fuse.
2. Switch device on again.
3. Eliminate cause of the
overheating, let cool
down for a few minutes,
then switch on again.
1. Clean, sharpen or
replace the blade.
2. Replace with the proper
type.
3. Remount the blade.
1. Replace blade.
2. Replace blade.
3. Tighten all hardware.
4. Reposition on flat
surface.
5. Replace blade.
1. Clean the gear and
screw post.
GB
IE
57