Titan TTB674TAS Instruction Manual page 35

TTB674TAS by TITAN
Overload reset switch
> This saw is equipped with a overload reset switch. It is situated at the immediate
top of the On/Off switch.
The overload reset switch [9] (See Fig. 24) will restart the motor after it shuts
off due to overloading.
If the motor stops during operation, push the switch to the OFF position. Wait
approximately five minutes for the motor to cool down and push the overload
reset switch. Now you can switch to the ON position again.
Warning: Risk of injury!
In order to avoid injury and prevent accidental start-up when the
overload reset switch is pushed, On/Off switch should be in the
OFF position, and the power cord should be unplugged from the
outlet while the saw is cooling down. Overheating may be caused
by an under-sized extension cord, an extension cord that is too
long, misaligned parts, or a dull blade. inspect the saw for proper
set-up before using it again.
Bevel locking handle
> The bevel locking handle [10] locks the blade in the desired tilting angle. To
loosen turn it anti-clockwise. When setting the angle of the cut fully loosen it.
Before turning the table saw ON, be sure it is securely tightened so that the
blade will not shift during the table saw operation. (See Fig. 25)
Product functions
GB
IE
35