Intended Use - Titan TTB674TAS Instruction Manual

TTB674TAS by TITAN

Intended use

When used for its intended purpose, this device corresponds to the state of the
art, as well as to the current safety requirements at the time of its introduction.
The device is intended for longitudinal and cross-cutting of solid wood, coated
wood, chip board, block board and similar woodlike materials. Round work pieces
may not be sawed since they can be twisted by the rotating saw blade.
Only materials may be processed for which the corresponding saw blade
is approved. The product must not be used for sawing firewood.
Only saw blades suitable for the device (HM saw blades) may be used. The use
of HSS saw blades and cut-off wheels of any type is forbidden.
The device is not suitable for commercial or industrial use.
Any other type of use is inappropriate. Improper use or modifications to the device
or the use of components that are not tested and approved by the manufacturer
may result in unforeseen damage!
Any use that deviates from its intended use and is not included in these
instructions is considered unauthorised use and relieves the manufacturer from
his or her legal liability.
WARNING: Before using your table saw, read the instruction
manual carefully.
WARNING: Carefully remove the table saw from the carton and
remove the protective foam from around the motor.
WARNING: Risk of injury!
Do not connect to the power supply before assembly, adjustment
and maintenance.
Unpack
> Unpack all parts and lay them on a flat, stable surface.
> Remove all packing materials and shipping devices if applicable.
> Make sure the delivery contents are complete and free of any damage. If you
find that parts are missing or show damage do not use the product but contact
your dealer. Using an incomplete or damaged product represents a hazard to
Before you start
GB
IE
15