Titan TTB674TAS Instruction Manual page 29

TTB674TAS by TITAN
Attach the table saw to the stand
> Place the stand on a flat surface.
> Place the table saw on top of the stand, aliging the holes in the base with the
holes in the stand.
Make sure that the front of the table saw positioned on the long side.
> Insert four hex bolts M6 x 25 [41] along with flat washers 6 [28] into the aligned
holes.
> Tighten all four hex nuts M6 [30] and hex bolts [41].
NOTE: Do not over-tighten the bolts that hold the saw to
the stand. Doing so will damage the saw base.
Fig. 20
35
Before you start
41
28
36
30
GB
IE
29