Features - MIMAKI Textile Jet Tx3-1600 Operation Manual

Features

The features and methods of operation are explained in this manual for you to understand how to use
the device properly.
Various textile printing ink can be used
MIMAKI genuine ink is shown below.
Acid dye ink
Reactive dye ink
Disperse dye ink
Printing pigment ink :
• When using any type of ink, be sure to perform the pre-processing and
• Use the printing pigment in an environment with humidity of 40% or more.
Automatic nozzle check function
Checks the print head condition automatically even during printing.
If a failure is detected, this function performs recovery operation, recheck, etc. according to
the setting. This function enables unattended print operation.
Applicability of fabric up to 7 mm in thickness
Even thick fabric, such as boards, can be used.
The plotter accepts fabric whose thickness is in the range of 0.1mm to 7.0mm.
Applicable to wide fabric
Fabric with up to 1650mm width can be set and printing for up to 1620mm width is possible.
Remaining ink management system with Ink IC tip
The IC chip mounted on the ink cartridge allows monitoring of the amount of remaining ink
even after it is removed and remounted.
This avoids INK END during unattended operation, allowing efficient use of ink and fabric.
LCD display
The LCD panel displays the device setting menu in two lines.
Since the LCD panel is provided with a backlight, the display can be seen clearly even in a
dark place. The LCD panel is capable of displaying seven different languages, including
English and Spanish.
: Suitable for wool, silk, and other animal fibers and nylon.
: Suitable for wool, silk in addition to cotton, rayon, etc.
: Suitable for fibers such as polyester, acrylic etc.
Use with cotton. Fixing with hot pressing is possible in postprocessing.
post-processing recommended by MIMAKI for the fabric used.
- ii -