Table of Contents
Advertisement
Warning message
Head
Unregistered ID
Media End
Print [ REMOTE ] Key
Mainte Cover
Close The Cover
Please Close The
Ink Station Door
Wiper
Replace Wiper
Wiper
Clean WiperShaft
Take-Up
Take-Up Limit
Take-Up
Check Tension
Take-Up
Take-Up Error
Feeding
Feeding Limit
Head Height
Check HeadHeight
Y Main Guide
Clean Main Guide
Cause
The head ID is not registered.
Fabric has been slacked by the
feeding tension bar position.
The front cover or station cover is
open.
The ink station cover is open.
Time to replace the wiper in the
capping station with a new one.
Time to remove ink adhered to
the bottom surface of the slider.
Cleaning period of the ink on the
wiper shaft of the capping station.
The take-up tension bar is
located at the top position for a
certain period of time or more.
The take-up tension bar is
located at the bottom position for
a certain period of time or more.
The tension bar is located at the
bottom position for a prolonged
time during heater setting is OFF.
The feeding tension bar is located
at the highest position for a
certain period of time or more.
Head guard sensor was detected.
Time to clean dirt from the main
guide.
- 6.7 -
Corrective measure
If this message appears again after
the power has been restored,
contact your dealer or Mimaki sales
office.
1. Press REMOTE key to start
printing.
2. Set the fabric again to remove
slacks. (Refer to Page 2.19)
Close the front cover or station
cover.
Close the ink station cover.
Printing will be enabled by pushing
the [REMOTE]. Then, the error
message will not appear until the
power is re-turned on. It is
recommended, however, to replace
the wiper with a new one as soon
as possible.
At the same time, clean the bottom
surface of the slider.
(Refer to Page 3.17)
Perform the carriage-out function of
the station maintenance (Refer to
Page 3.15 ) to clean the wiper shaft
of the capping station. When the
carriage-out function is performed,
the warning message disappears.
Check the fabric and perform the
fabric reset. (Refer to Page 2.19)
Check the fabric and take-up
tension bar, or raise the tension
bar.
Check the fabric and take-up
tension bar, or raise the tension
bar.
Lower the feeding tension bar and
check the fabric and take-up
tension bar.
Check the condition of the fabric
retainer and fabric surface (slacks,
float).
Execute Maintenance Function-
Main Guide to clean the Y main
guide axis. When Carriage Out is
executed, this warning message
disappears. (Refer to Page 3.27)
Advertisement
Table of Contents
