Table of Contents
Advertisement
Printing HEX Code Of Printing Command [Data Dump]
This function plots data commands received from the computer, in HEX code.
The HEX code is an alphanumeric representation of printing commands.
By using this code, it is possible to check if there are any abnormal data commands.
• When this function is used to output data commands on a fabric, use A4 or
larger size with the long side set horizontally.
• DATA DUMP automatically feeds line according to the size of fabric used.
STEP
1. Make sure the fabric has set on the belt.
2. Put the device into the MAINTENANCE mode.
(Refer to Page 5.3)
3. Press [ENTER] key.
4. Press [ ] and [ ] key until the display gives
the indication [Data Dump].
5. Press [ENTER] key.
6. The transfer data from the host computer.
Drawing the DATA DUMP is started.
7. When printing is completed, press
[REMOTE] key.
8. Perform the data clear operation.
(Refer to Page 2.49)
*DATA DAMP
- 5.14 -
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
Station
< ent >
MAINTENANCE
Data Dump
< ent >
Data Dump
∗∗ Data Dump ∗∗
Please Wait
<< LOCAL >>
width : 1620mm
Advertisement
Table of Contents
