Table of Contents
Advertisement
Drawing Setup Conditions [List]
This function outputs the current settings of the device.
They are useful in carrying out maintenance of the device.
Explanation of the list
1. SET UP
2. PrintAdjust
3. REPLACE COUNTER
4. VERSION
5. PARAMETER
STEP
1. Make sure the fabric has set on the belt.
2. Put the device into the MAINTENANCE mode.
(Refer to Page 5.3)
3. Press [ENTER] key.
4. Press [ ] and [ ] key until the display gives
the indication [List].
5. Press [ENTER] key.
6. Press [ENTER] key again.
Printing the LIST is started.
7. The device enters the LOCAL mode.
*LIST
:
Indicates a value that is specified with the FUNCTION.
:
Indicates a correction value for dot position.
:
Indicates the number of times the ink cartridges are
replaced.
:
Indicates the version of the firmware and memory
capacity of the device.
:
Used for service persons for maintenance.
- 5.13 -
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
Station
< ent >
MAINTENANCE
List
< ent >
List
Print
∗∗ Printing∗∗
Please Wait
<< LOCAL >>
width : 1620mm
: ent
Advertisement
Table of Contents
