Table of Contents
Advertisement
Configuration And Function
Front face
17
Name
1.
Station cover L
2.
Peeling sensor
3.
Belt encoder roller
4.
Front cover
5.
Peeling roller
6.
Belt
7.
Peeling sensor amp
8
ANR unit
9.
Station cover R
10.
Indicator
11.
Operation panel
12.
Waste ink tank
13.
Ink station
14.
Take-up tension bar stopper
15.
Take-up tension bar
16.
Heater
17.
Fabric edge guide
18.
Take-up device
19.
Heater cover
20.
Roll holder
*1: Depending on the plotter, this may be attached on the outside of the device.
2
3
1
20
19
18
It is opened when maintenance of the back side of carriage.
Monitors the peeling position of the fabric.
Checks the amount of belt movement.
It is opened when setting fabric or maintenance internal of the station.
Peels off the fabric from the belt.
Transports the fabric.
Control the peeling sensor.
Check the ink clogging or deflection during printing.
It is opened when maintenance of the station. (Refer to Page 1.10)
Green: Data receiving, printing, Red: Error (stop printing)
Red is blinking: warning error
This panel has the operation keys required for operating the printer and
the LCD for displaying set items, etc.
Collects waste ink that has been used for cleaning.
Loads ink cartridges or ink pack for ink supply to each head.
The tension bar is hooked to this stopper when leading the fabric. *1
Applies proper tension to the fabric to control operation of the take-up
device.
Dries the fabric after printing.
The fabric peeling operation enables to perform more properly.
It supports to wind up the roll fabric printed, and have the operation
named FORWARD / OFF / REVERSE.
Protect the heat from the heater
Light weight roll holder is inserted in the right and left core of roll fabric
to hold the roll fabric. The roll holder is applicable to diameter of fabric
cores with1.35 to 3 inches.
4
5
6
7
17
16
15
Function
- 1.6 -
10
11
9
8
13
12
14
Advertisement
Table of Contents
