Switching On / Off The Power Supply; Turning The Power On - MIMAKI Textile Jet Tx3-1600 Operation Manual

Switching ON / OFF The Power Supply

After setting up the device, switch on and off the power as described below.

Turning the power on

STEP
1. Turn on the power to the blower.
2. Turn on the power to the heater.
3. Turn on the power to the device.
4. Turn on the power to the computer, etc. that
are connected to the device.
• At this time, the front cover and station
cover L,R must be closed.
With the front cover kept open, the carriage
does not move even when the power is
switched on.
• Since the heater indicator displays the
operating status, it may not light on even if
the power is turned ON.
When the power is turned on, [BOOT] is displayed, then the model
name and firmware version is shown.
The message "Please Wait" appears flashing on the LCD.
The initialization process is displayed.
The device enters the fabric width detection.
- 1.20 -
BOOT
Tx3-1600
Please Wait
∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ − − − − − − − −
MEDIA SET
ROLL< > LEAF
V.1.00