Drawing An Image From Source Data; Starting The Drawing Operation - MIMAKI JFX-1631/1615 Operation Manual

Drawing an image from source data

Starting the drawing operation

• If the UV irradiation device is not ready or the temperature of the water heating system has not reached
the predetermined value, a message is displayed. Drawing is not allowed in such cases. When the
display is disappeared, drawing can be started.
• Data transmission is allowed even if both errors are displayed. Drawing is started after the display is
disappeared.
1
Set the media (
(1) Open/Close the suction valve adjusting to the media size.
(2) Pressing the
(3) Pressing the
2
Press the
• The device goes in the remote mode and data from the computer
can be received.
3
Transmit data to be drawn from the computer
• Drawing conditions are displayed.
• As for the data transmission method, see the instruction manual
of the output software.
4
Start drawing
• The drawing origin is not changed after completion of the drawing.
P.2-5)
key, put on the VACUUM lamp.
VACUUM/BLOW
key, absorb the media.
ON/OFF
key in the local mode.
REMOTE
* R EMO T E *
Resolution: 600DPI
* R EMO T E *
HOS T / 4 P / B / N
Scanning speed:
"N" denotes normal.
"x2" denotes the
double speed.
Direction:
"B" denotes bi-directional.
"U" denotes uni-directional.
Pass
Priority is set to "HOST" :
"HOST" is displayed.
Priority is set to "PLOT" :
Print quality (STD/FINE/FASR) is
displayed.
2 . 5 mm
2
6 0 0 X 6 0 0
2 . 5 mm
2-11