Plotting An Image From Source Data; Starting The Plotting Operation - MIMAKI JV3-250 SP Operation Manual

Plotting an Image from source data

Starting the plotting operation

The following describes the mode selection for data reception from the computer and LCD display
during plotting.
For various function settings necessary for plotting, refer to "CHP4 Setting Function".
When plotting is started, the LCD displays the following information.
∗ REMOTE ∗
S T D
QUALITY STD : STANDARD, FINE : HIGHQUALITY, FAST : HIGHSPEED
STEP
1. Check the heater temperature.
Make sure that the CONSTANT indicator on the heater panel
rights.
2. Push the [REMOTE] key.
The type of the currently selected plotting condition can be
confirmed.
3. Transmit data from the computer.
The plotting conditions that have been set for the data are
displayed.
For the method of data transmission, see the manual for the
output software.
4. During the plotting.
During the plotting operation, the length of the media plotted
on is displayed.
5. After the plotting operation is completed, push
the [REMOTE] key to put the device back into
the LOCAL mode.
Downloaded From ManualsPrinter.com Manuals
• When in use of a roll media, make sure the back side of roll media is not
loosened before executing plotting. The loosened media will cause the
inferior image quality.
3 6 0 x 3 6 0
/ 4 / U / 0. 5 0 m
Passes : 2pass - 16pass
HOST : When plot setting is made on the computer
page 1.9, 2.29
page 4.4
Resolution: 360/540/720 DPI
Length of medium that has been plotted on
Dividing method : U : Unidirectional, B : Bidirectional
- 2.36 -
∗ REMOTE ∗
TYPE. 1 0. 0 m
∗ REMOTE ∗ 3 6 0 x 3 6 0
S T D / 4 / U / 0. 5 0 m
< LOCAL >
width : 2475 mm