Drawing An Image From Source Data; Starting The Drawing Operation - MIMAKI JF-1631 Operation Manual

Drawing an image from source data

Starting the drawing operation

• If the UV irradiation device is not ready or the temperature of the water heating system has not
reached the predetermined value, a message is displayed. Drawing is not allowed in such
cases. When the display is disappeared, drawing can be started.
• Data transmission is allowed even if both errors are displayed. Drawing is started after the
display is disappeared.
1
Set the media（
(1) Open/Close the suction valve adjusting to the media size.
(2) Pressing the
(3) Pressing the
(In the case of JF-1610, press the
2
Press the
mode.
• The device goes in the remote mode and data from the computer can be received.
• If the UV lamp is off, it will be lit.
3
Transmit data to be drawn from the
computer
• Drawing conditions are displayed.
• As for the data transmission method, see the
instruction manual of the output software.
4
Start drawing
• The drawing origin is not changed after completion of the drawing.
5
Taking out the media after completion of drawing
(1) Press the
(2) "Evacuation of Y-bar from the table"（
(3) Remove the media.
• During printing, media may be heated by the UV lamp and raised, causing drawing to be
interrupted. In this case, set new media and restart drawing.
2-12
P.2-5）
key, put on the VACUUM lamp.
VACUUM/BLOW
keys, absorb the media.
FRONT REAR
key in the local
REMOTE
key to light the BLOW lamp.
VACUUM/BLOW
key to absorb the media.)
ON/OFF
Priority is set to "HOST" :
"HOST" is displayed.
Priority is set to "PLOT" :
Print quality (STD/FINE/FASR) is displayed.
P.2-14） to evacuate the Y-bar out of the table.
* R EMO T E *
2 . 5 mm
Resolution: 600DPI
* R EMO T E * 6 0 0 X 6 0 0
HO S T / 4 P / B / N 2 . 5 mm
Scanning speed:
"N" denotes normal.
"H" denotes the
double speed.
Direction:
"B" denotes bi-directional.
"U" denotes uni-directional.
Pass