Remote Management - TP-Link TL-WR841HP User Manual

By default, the radio button "All the PCs on the LAN are allowed to access the router's
Web-Based Utility" is checked. If you want to allow PCs with specific MAC Addresses to
access the Setup page of the router's Web-Based Utility locally from inside the network, check
the radio button "Only the PCs listed can browse the built-in web pages to perform
Administrator tasks", and then enter each MAC Address in a separate field. The format for the
MAC Address is XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). Only the PCs with MAC
address listed can use the password to browse the built-in web pages to perform Administrator
tasks while all the others will be blocked.
After click the Add button, your PC's MAC Address will be placed in the list above.
Click the Save button to save your settings.

Note:
If your PC is blocked but you want to access the router again, use a pin to press and hold the
WPS/Reset button (hole) on the back panel for about 5 seconds to reset the router's factory
defaults on the router's Web-Based Utility.

3.4.8.4. Remote Management

Go to "Advanced→Security→Remote Management", and then you can configure the Remote
Management function in this page. This feature allows you to manage your router from a remote
location via the Internet.

Web Management Port - Web browser access normally uses the standard HTTP service
port 80. This router's default remote management web port number is 80. For greater
security, you can change the remote management web port to a custom port by entering
TL-WR841HP 300Mbps High Power Wireless N Router
-59-