TP-Link TL-WR841HP User Manual page 44

Wireless Network Name - The wireless network name (SSID) that the router uses. You

can create a new one with up to 32 characters. The default SSID is set to be
TP-LINK_XXXX. This value is case-sensitive. For example, TEST is NOT the same as
test.
Mode - Select the desired mode.


11n only - Select if you are using only 802.11n wireless clients.

11gn mixed - Select if you are using both 802.11n and 802.11g wireless clients.

11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
It is strongly recommended that you set the Mode to 802.11bgn mixed, and all of
802.11b, 802.11g, and 802.11n wireless stations can connect to the router.
Channel Width - Select the channel width from the drop-down list, including Auto,

20MHz, and 40MHz
 Channel - This field determines which operating frequency will be used. The default
channel is set to Auto, so the router will choose the best channel automatically. It is not
necessary to change the wireless channel unless you notice interference problems with
another nearby access point.
 Enable Wireless Router Radio - The wireless radio of the Router can be enabled or
disabled to allow wireless stations access. If enabled, the wireless stations will be able to
access the Router. Otherwise, wireless stations will not be able to access the Router.
Enable SSID Broadcast - When wireless clients survey the local area for wireless networks

to associate with, they will detect the SSID broadcast by the router. If you select the Enable
SSID Broadcast checkbox, the Wireless router will broadcast its name (SSID) on the air.
TL-WR841HP
.
300Mbps High Power Wireless N Router
-35-