Dhcp - TP-Link TL-WR841HP User Manual

Click the Start button to start wireless throughput monitor.
Click the Stop button to start wireless throughput monitor.

4.3.4 DHCP

There are three submenus under the DHCP menu: DHCP Settings, DHCP Client List and
Address Reservation. Click any of them, and you will be able to configure the corresponding
function.
4.3.4.1. DHCP Settings
Go to "Setting→DHCP→DHCP Settings", and then you can configure the DHCP Server on the
page as shown below. The Router is set up by default as a DHCP (Dynamic Host Configuration
Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are connected to
the Router in the LAN.
 DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must
have another DHCP server within your network or else you must configure the computer
manually.
Start IP Address - Specify an IP address for the DHCP Server to start with when

assigning IP addresses. 192.168.0.100 is the default start address.
 End IP Address - Specify an IP address for the DHCP Server to end with when assigning
IP addresses. 192.168.0.199 is the default end address.
 Address Lease Time - The Address Lease Time is the amount of time a network user
will be allowed connection to the Router with their current dynamic IP Address. Enter the
TL-WR841HP 300Mbps High Power Wireless N Router
-115-