Dhcp Settings - TP-Link TL-WR841HP User Manual


Access Time - During this time the wireless stations could accessing the AP.

Note:
The range of bandwidth for Guest Network is calculated according to the setting of Bandwidth
Control on the page "Bandwidth Control->Control Settings".
3.4.6 DHCP
There are three submenus under the DHCP menu: DHCP Settings, DHCP Client List and
Address Reservation. Click any of them, and you will be able to configure the corresponding
functions.

3.4.6.1. DHCP Settings

Go to "Advanced→DHCP→DHCP Settings", you can configure the DHCP Server on the page
as shown below. The router is set up by default as a DHCP (Dynamic Host Configuration
Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are connected to
the router on the LAN.
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must

have another DHCP server within your network or else you must configure the computer
manually.
Start IP Address - Specify an IP address for the DHCP Server to start with when

assigning IP addresses. 192.168.0.100 is the default start address.
End IP Address - Specify an IP address for the DHCP Server to end with when assigning

IP addresses. 192.168.0.199 is the default end address.
TL-WR841HP 300Mbps High Power Wireless N Router
-47-