System Requirements; Installation Environment Requirements; Connecting The Router; Chapter 2. Connecting The Internet - TP-Link TL-WR841HP User Manual

Chapter 2. Connecting the Internet

2.1 System Requirements

 Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is

connected directly to the Ethernet.)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

 TCP/IP protocol on each PC
Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari


2.2 Installation Environment Requirements

Place the router in a well-ventilated place far from any heater or heating vent

Avoid direct irradiation of any strong light (such as sunlight)

Keep at least 2 inches (5 cm) of clear space around the router

Operating Temperature: 0℃~40℃ (32℉~104℉)

Operating Humidity: 10%~90%RH, Non-condensing


2.3 Connecting the router

2.3.1 Before you start

Before installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP.
Please choose the operation mode you need and carry out the corresponding steps. There are
three operation modes supported by this router: Router, Range Extender and Access Point.
Please install the Antennas first by following the steps shown below before your start to use the
router.
TL-WR841HP 300Mbps High Power Wireless N Router
-6-