PowerLogic EGX200 Instruction Bulletin page 16

Chapter 3—Getting Started
EGX200 Initial Setup
The Communications Settings page displays, as shown in Figure 3–7.
Figure 3–7: Communications Settings page
10. Enter your IP Address, Subnet Mask, and Router IP address, and click Update.
11. Reset your PC back to its original network configuration.
Now you are ready to install and use the EGX200 on your Ethernet network. Refer to
Chapter 4 and Chapter 5 for more information.
12 © 2001 Schneider Electric All Rights Reserved
63230-314-200/A2
8/2001