Heart Rate Test; Safety Key Test; Belt Alignment Test (Procedure); Incline Calibration - Bodyguard T-30 User Manual

6.6

HEART RATE TEST

The HEART RATE TEST allows you to verify if the two heart rate systems, wireless chest strap and
contact heart rate sensors, are functioning correctly.
Once the HEART RATE TEST has been selected the test will automatically begin. You do not have
to be walking on the belt to do this test; you may stand on the foot rails.
Place your hands on the contact heart rate sensors and after 10 seconds your heart rate should be
displayed in the bottom center of the display.
Put on a compatible wireless heart rate chest strap. If a heart rate chest strap signal is detected by
the wireless receiver in the console the value will be displayed in the bottom left-hand side of the
display. Press the STOP key to end the test.
If either system does not function or is erratic refer to Heart Rate Troubleshooting in section 8.6.
6.7

SAFETY KEY TEST

The SAFETY KEY TEST allows you to verify if the Emergency Stop System is functioning correctly.
Once the SAFETY KEY TEST has been selected the test will automatically begin.
If the safety key is removed from its slot or not functioning correctly then ''SAFETY KEY OFF'' should
be displayed. Press the STOP key to end the test.
6.8

BELT ALIGNMENT TEST (PROCEDURE)

Should you need to adjust the alignment of the walking belt, it is recommended you make all
adjustments during the BELT ALIGNMENT TEST.
Once BELT ALIGNMENT has been selected the test will begin automatically.
For instructions on completing a Walking Belt Alignment see section 7.5.
6.9

INCLINE CALIBRATION

The INCLINE CALIBRATION feature attempts to recalibrate the incline motor to its correct settings.
During an INCLINE CALIBRATION the treadmill will incline all the way to its highest level and then to
its lowest level before returning to a zero position. The calibration usually takes about 1 minute to
complete. The safety key must be in to complete an incline calibration.
Note: An INCLINE CALIBRATION must always be performed after a new Motor Control Board is
installed or if the INCLINE MOTOR becomes stuck in the wrong position.
Completing an incline calibration on a T-30 is done manually, please contact your Bodyguard Service
Provider or the Bodyguard Customer Service department for assistance.
On a T-45 & T-75, an incline calibration can be easily performed by selecting INCLINE
CALIBRATION in the Diagnostics Menu. PLEASE WAIT will display on the screen. The calibration
will proceed automatically.
If the INCLINE CALIBRATION fails to solve an incline problem, check the status code on the motor
control board and for any error codes on the display and see Troubleshooting Problems in section 8.
TREADMILLS – USER MANUAL
45