Using The Emergency Stop System - Bodyguard T-30 User Manual

TREADMILLS – USER MANUAL
2.4

USING THE EMERGENCY STOP SYSTEM

This treadmill is equipped with an emergency stop system comprising of a clip tied to a safety key
that slots into a safety switch inside the console. When the clip is pulled the safety key is removed
from the its slot in the console, opening the safety switch which will stop the walking belt and place
the console into a pause mode for the countdown duration displayed on the screen.
Before starting your workout, test that this system works correctly by following the steps below.
Step onto the treadmill's foot rails.
Attach the clip to your clothing and make sure the safety key is located in its correct slot on the
console.
Press the JUSTGO button.
If the emergency stop system is functioning correctly a 3, 2, 1 countdown will begin and the treadmill
belt will start to move at 0.5mph or km/h.
Grip the handrails and carefully step onto the belt and begin walking making sure you are located in
the middle of the workout area. Stop walking and let the belt slowly take you to the back of the
treadmill belt area. As you approach the rear of the treadmill the range of the clip cord will be maxed
out and will pull and remove the safety key from its location on the console causing the walking belt
to stop.
If you feel the distance is too long before the safety key is removed, you may reduce the length of the
cord. IMPORTANT: For your safety, DO NOT LENGTHEN the cord under any circumstances.
Always use the emergency stop system when exercising on the treadmill. If the safety key is
removed while you are exercising, the walking belt will come to a stop and the treadmill will enter into
a PAUSE mode. You will need to place back the safety key into its correct position and press the
JUSTGO key to resume the workout.
13