Errors, Warnings And Messages During Start Up; Switching To Standby - Barco FLM R20+ Performer User Manual

6. Getting started
The actual input voltage is indicated on the voltmeter just above the power switch.
Starting image projection via the standby key.
1. Press Stand by key once on the local keypad or on the remote control.
4
1 2 3
6 7 8 9
RGB PATTERN WINDOW PIP
STBY PAUSE TEXT AUTO
A
Image 6-3
Stand by indication
A Stand by indication on local keypad
B Stand by indication on remote control
The projector status LED lights up.
The projector starts up on the last saved source.
Some lamp and runtime warnings can be displayed when an image is displayed after a start up.
Starting image projection via source selection
1. Press the desired source number on the remote control or the local keypad.
If the source is available, the projector starts up and the projector status LED lights up
Some lamp and runtime warnings can be displayed when an image is displayed after a start up.
6.3.2

Errors, warnings and messages during start up

Temperature error DMD
When the temperature of one of the DMD's is too low or too high the projector is switched automatically to standby. An error code
will be displayed on the local LCD panel. For a list of possible error codes, see "Error codes", page 145.
6.3.3

Switching to standby

How to switch to standby?
1. Press Standby to switch the projector to standby.
44
B
5
EXIT
MENU
0
LENS
ENTER
RIGGING
i
MENU
EXIT
ENTER
TEXT
PAUSE LENS
PHASE
9 0
SHARPN
7 8
TINT
6
5
COLOR
3 4
BRIGHTN
2
1
CONTR
LENS
LENS
ZOOM SHIFT
LENS
LENS
SHIFT
FOCUS
R5976921 FLM R20+ PERFORMER 08/03/2006