Alignment Of A Table Mounted Projector; Mounting The Bottom Carry Handler - Barco HDX 4K User Manual

3. Physical Installation
C
AUTION
imately five minutes to ensure that the projector and lamp have sufficiently cooled, at which point the fans
will automatically decrease to standby. To avoid thermal stress that can lead to premature lamp failure, never
unplug the power cord while the lamp cooling fans are running. Never unplug the power cord to power down
the projector, first switch off the power switch and then unplug the power cord.
Fuses
The projector is protected with an automatic circuit breaker of 20 A which is built into the power switch.
The voltage meter is protected with a fuse (1A) which is located on the neutral bonding cable. If necessary to replace this fuse,
consult a service technician.
3.2

Alignment of a table mounted projector

How to align
1. Place the projector in the desired location. Take into account the zoom range of the used lens and the size of the screen.
2. Project one of the internal hatch patterns on the screen.
3. Turn the adjustable feet in or out until the projected hatch pattern has a perfect rectangle shape and is leveled.
Image 3-2
Level alignment
When this is achieved, the projector is set horizontal and vertical at right angles to the screen.
Image 3-3
Angle adjustment
3.3

Mounting the bottom carry handler

Necessary tools
Open wrench 17 mm
Necessary parts
4x bolt M10 x 16 mm
How to mount
1. Turn the projector upside down.
2. Turn out the 4 feet.
22
:
Once the projector is switched to standby, the lamp cooling fans will continue to run for approx-
R5906070 HDX 4K 23/09/2016