Hard Disk Test - Toshiba T200 User Manual

3.11 Hard Disk Test

To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TESTS menu, tap or press
Enter , and follow the directions displayed on the screen. Ten subtests test the HDD func-
tions. The following messages will appear after the hard disk test is selected. Answer each
question with an appropriate response.
CAUTION: The contents of the hard disk will be erased when subtest 02, 03, 04, 05,
06, 08, 09, or 10 is executed. Before running the test, transfer the contents of the hard
disk to a floppy disk(s).
After the hard disk test is completed, set the partition. Refer to the customer's operat-
ing system documentation for details on partitioning the disk .
1. When the hard disk test is selected, the following message will appear:
Test drive number select :
Select the HDD number to be tested and tap or press Enter . The following mes-
2.
sage will appear:
HDC F/W error retry
3. This message is used to select the retry operation when the hard disk controller
detects an error. Select 1 or 2 and tap or press Enter . The following message
will appear:
Data compare error dump :
4. This message is used to select the error dump operation when a data compare
error is detected. Select 1 or 2 and tap or press Enter . The following message
will appear:
Detail status display :
5. This message is used to select HDD status for display or non-display. The HDD
status is described in section 3.17. Select 1 or 2 and tap or press Enter .
6. The Hard Disk Test message will appear after a response to the Detail Status
prompt. Select a subtest to execute and tap or press Enter . The following mes-
sage will appear during each subtest.
HARD DISK TEST
SUB-TEST
PASS COUNT : XXXXX
WRITE DATA : XX
ADDRESS
T200, T200CS
: YES
NO
NO
XXXXXXX
: XX
ERROR COUNT : XXXXX
READ DATA
: XXXXXX STATUS
HDD#1 HDD#2 HDD1&2
NO
YES
YES
: XX
: XXX
3-25