Toshiba T200 User Manual page 147

5. Remove the FL unit cover and tape securing the reflective sheet.
6. Lift up the reflective sheet covering the LCD panel (Figure 4-27).
CAUTION: When you remove the FL, do not lift up the FL panel, which is
attached to the reflective sheet covering the FL. The FL panel is highly
sensitive to dust, so be very careful not to expose it.
7. Lift out the FL (Figure 4-27).
Installing the T200CS FL
To install the T200CS's FL, follow the steps below and refer to Figures 4-25 through 4-27.
1. Place the FL on the FL unit and cover the FL using a reflective sheet (Figure 4-27).
2. Secure the reflective sheet with tape.
3. Place the FL unit cover and secure it with six M2x2 flat screws (Figure 4-26).
4. Secure the FL unit with four M2.5x4 screws (Figure 4-25).
5. Install the tablet, FL inverter board, lower system board, upper system board, backup
battery, RTC battery, back cover, HDD, optional PCMCIA card, optional memory
card, and battery pack as described in sections 4.2 through 4.10, and 4.12.
T200, T200CS
Figure 4-27 Removing the T200CS FL
4-37