Toshiba T200 User Manual page 145

4.15 T200 FL
Removing the T200 FL
To remove the T200's FL, follow the steps below and refer to Figure 4-24.
1. Turn off the power to the computer. Disconnect the AC adapter, and all external cables
connected to the computer.
2. Remove the battery pack, optional memory card, optional PCMCIA cards, HDD,
back cover, upper system board, backup battery, RTC battery, lower system board,
FL inverter board, and tablet as described in sections 4.2 through 4.8, 4.10, and 4.11.
3. Carefully lift out the FL unit from the display module.
4. Remove the two M2x2.5 flat screws securing the FL cover (Figure 4-24).
5. Unlatch the four latches to remove the FL.
Installing the T200 FL
To install the T200's FL, follow the steps below and refer to Figure 4-24.
1. Snap in the four latches of the FL cover to the FL unit.
2. Secure the FL cover with two M2x2.5 flat screws (Figure 4-24).
3. Place the FL unit on the LCD panel.
4. Install the tablet, FL inverter board, lower system board, upper system board, backup
battery, RTC battery, back cover, HDD, optional PCMCIA card, optional memory
card, and battery pack as described in sections 4.2 through 4.8, 4.10, and 4.11.
T200, T200CS
Figure 4-24 Removing the T200 FL
4-35