Toshiba T200 User Manual page 35

Table 2-1 Printer Port LED Boot Mode Error Status (2/2)
Error status Test item
4AH* PIC test
50H Mouse initialization
55H KBC initialization
5AH Boot password1
(checks for access right)
60H HDD initialization
65H FDD initialization
70H Printer test
80H RS-232-C test
90H Timer initialization
A0H NDP initialization
A6H Expansion I/O ROM
C0H Boot password2
(checks for no access right)
FEH Pre-boot setup
FFH Expansion system ROM
NOTES:
* These error codes are not displayed on hot boot mode.
** This error code is not displayed on cold boot mode.
Check 1 If any of the following error codes are displayed, go to Procedure 5.
01h, 02h, 03h, 04h, 05h, 06h, 07h, 08h, 09h, 0Ah, 0Bh, 0Ch, 0Dh, 18h, 1Fh,
25h, 30h, 33h, 40h, 41h, 42h, 4Ah, 50h, 55h, 5Ah, 60h, 65h, 70h, 80h, 90h,
A0h, A6h, C0h, FEh
Check 2 If error code 5Ah is displayed, go to the HDD Troubleshooting Procedures in
Section 2.6.
Check 3 If error code 60h is displayed, go to the FDD Troubleshooting Procedures in
Section 2.5.
T200/T200CS
Message
PIC #1 ERROR
READ DATA = XXH
WRITE DATA = XXH
PIC #2 ERROR
READ DATA = XXH
WRITE DATA = XXH
-
KBC ERROR
-
HDC ERROR
HDC #0 ERROR
HDC #1 ERROR
NO FDD ERROR
FDD ERROR
-
-
TIMER INTERRUPT ERROR
RTC UPDATE ERROR
-
-
-
-
-
2-15