Installing the T200 Tablet
To install the computer's tablet, follow the steps below and refer to Figures 4-17 through 4-19.
1.
Place the tablet on the LCD panel (Figure 4-19), and tablet cover on the tablet
(Figure 4-18). When you seat the tablet, align the holes at each corner with the corre-
sponding posts on the LCD module.
2.
Place the middle frame on the display module and make sure that the cabling is
covered, then snap the four latches into place (Figure 4-17).
3.
Secure the middle frame with the two 2.5x4 screws (Figure 4-17).
4.
Install the FL inverter board, lower system board, upper system board, backup battery,
RTC battery, back cover, HDD, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.2, 4.3, 4.4, 4.5, 4.6, 4.7, 4.8, and 4.10.
T200, T200CS
4-29